Electric utility articles

Why do generators have to match the grid before connecting?

A round synchroscope dial set into a generator control panel

A spinning generator makes an AC voltage that rises and falls over and over. The grid’s voltage is doing the same thing. Before closing the breaker between them, the plant wants the two voltages close in size, frequency, and timing. That’s called synchronizing.

What happens if the timing is off?

Think about two people lifting opposite ends of a table. If one lifts early and the other late, there’s a jerk. Two AC sources connected at very different points in their cycles can drive a large current between them and put a sudden strain on the generator shaft.

How can the plant see the difference?

A synchroscope can show how the timing of the generator is moving relative to the grid. Many plants use automatic controls to make the adjustments and check that conditions are right before the breaker closes.

For more on how generators connect to an AC grid, see Basics of Electric Utilities 101.