One full day8:00 a.m.–5:00 p.m. with eight hours of instruction
Technical courseFiber, wireless and utility network architecture
Applied exercisesService requirements and a network design case
Course overview
Follow operational data from a field device to the control center and back. Compare networks that support transmission protection, substation automation, distribution switching and metering. Use a design case to weigh performance, coverage, availability and lifecycle cost.
Learning objectives
Trace data and control traffic from field equipment to the control center.
Compare fiber, microwave, licensed radio and cellular for utility applications.
Translate application needs into latency, availability and coverage requirements.
Identify shared failure points and define checks for service restoration.
Who should attend
Utility engineers, telecommunications and SCADA staff, protection technicians, control center operators, planners and project managers.
IT and operations technology teams, contractors and vendors can use this course to build a shared vocabulary for planning, commissioning and supporting utility networks.
From field signal to control center
Collect at the edge
Connect field equipment.
Field equipment generates measurements and status information.
Carry across the network
Choose a path for each service.
The communications link carries that information across the utility network.
Act at the control center
Give operators usable information.
Control-center systems make it available for monitoring and coordination.
Course content
Compare network choices in the context of real utility applications, from routine meter traffic to time-sensitive protection.
Utility applications and service requirements
Compare communications needs for supervisory control and data acquisition (SCADA), teleprotection, distribution automation, advanced metering and field voice.
Translate application needs into bandwidth, latency, jitter, availability and recovery requirements. Explain why an acceptable metering delay may be unsuitable for protection.
Architecture and traffic flow
Trace traffic through field area networks, substation LANs, WAN backhaul and control center systems. Identify the roles of relays, remote terminal units, gateways, switches and routers.
Compare point-to-point, ring, star and mesh arrangements. Distinguish logical redundancy from physically diverse routes and independent power.
Fiber and wireless media
Compare optical ground wire, all-dielectric self-supporting cable and underground fiber by installation constraints, repair access and route diversity. Read an illustrative optical loss budget.
Compare microwave, licensed land mobile radio, private or commercial cellular, and satellite options. Consider line of sight, terrain, spectrum, coverage and backup power.
Protocols, time and legacy migration
Compare the roles of DNP3, IEC 61850 and Ethernet/IP in field and substation communications. Discuss where serial links and legacy time-division multiplexed services still fit.
Explain how time synchronization supports event correlation. Compare the migration needs of routine telemetry and time-sensitive protection traffic.
Reliability and operational support
Review traffic prioritization, failover, route diversity and station backup power. Discuss network segmentation, access control and monitoring as defensive design practices.
Define acceptance checks for latency, loss and recovery. Use sample alarms and timestamps to distinguish loss of communications from a field device or application issue.
Network design and restoration case
Compare two backhaul options for a transmission substation and remote distribution switches. Weigh service performance, coverage, route diversity, maintainability and lifecycle cost.
Evaluate how a shared route or loss of station power changes service availability. Identify what operators should confirm before returning to normal service.
Course recap & participant questions
Review the design case, explain which services should stay available during an outage, and discuss how the trade-offs apply to your own network.
Agenda
8:00 a.m.–5:00 p.m., including eight hours of instruction, two 15-minute breaks and a 30-minute lunch.